After turning on the software, you need to create text or load a selected graphic.
Then we move on to filling, to do this we click on the large letter H located under the menu.
In the filling window we set:
- Filling 1
- Filling type as in the picture below
- 45 angle
- Repetition 1
- Density 0.04
- Loop distance 0.5
- 90 Degrees
NOTE! Please note that the settings may change depending on the product you want to engrave
After setting the basic parameters, you need to set the appropriate height (focus).
To do this, place the gadget you want to mark on the rotary attachment and then click Beam (F1). Two red spots will appear on our gadget, which we need to merge into one by rotating the upper part of the machine arm to the left or right.
After setting the height, go to the rotary attachment settings, click the “Laser” menu and then “Rotary mark”.
In the newly opened window, set the initial settings for the engraving on the rotation:
Distance per 5.00
Splite size 0.100
Select “Reverse”
In the “Part diameter” position, enter the diagonal of our cup/gadget
ATTENTION!
Remember that the settings may change, depending on the product you want to engrave
After setting the parameters, go to the “Parameters” window (F3) and set the parameters according to the image below:
In the “Part diameter” category (right side), the previously assigned diagonal parameter will be loaded
